Peugeot Expert 2.0 16V HDI 120 Performance Remap:


Stage 1 Power


Stage 1 Torque

Citroen Dispatch

Peugeot Expert 2.0 HDI 120 Stage 1 Remap (Roetfilter verwijderen if fitted, Siemens SID803) - Our Stage 1 remap gives 170BHP and torque of 390Nm. We've developed these remaps not only to give optimal performance, but also to remain within the limits of the stock hardware of your vehicle so you don't need to worry about your clutch or your dual mass flywheel. Power delivery will be smooth and constant through the entire engine range and will make overtaking much easier.

Some models of the 2.0 HDI 120 come fitted with a DPF system, you'll need to remove this for the full power stage 1 remap if it is fitted. Luckily HDI Tuning Ltd have a safe and reliable Roetfilter verwijderen solution which won't give future problems (many other companies will use software to remove the DPF which can cause turbo problems).

Take a look at a dyno print out for the 2.0 136 engine:

2.0 16V 136 HDI Dyno print out - 165 BHP or 170 BHP

Peugeot Expert 2.0 HDI Stage 1 Remap - If you van has a DPF fitted and you're looking for a power increase without modifying your car, then the best option for you is our DPF friendly remap. This keeps AFR high to prevent the DPF filter from clogging. You'll still get good power gains with 165 BHP and 370 Nm of torque.

Online price: If you have the correct equipment you can read/write the ECU yourself, the remap is just £99. For both SID803 and also SID803A you can open the ECU and program to the BDM pads, we have a video guide available. If you have the SID803A then you can also program this one direct through the OBD port using Kess V2 (this does not work for SID803 and the maps are in the processor instead of the flash memory).

Postal remap service: You can send us your ECU and let us do all the hard work for you. Price £150.

EGR verwijderen

The EGR is tricky to get to on the 2.0 16v engine, and the plug needs to be removed from the solenoid before we can delete the EGR function. If you can fit an EGR blanking plate before your remap this will be beneficial, but it isn't 100% necessary if the EGR is not stuck open, as removing the electrical connector will prevent it from operating, associated faults will be removed from the ECU.

If you're not sure if you require EGR verwijderen, please read here.

Important: These options are only available for cars fitted with the Siemens SID803 or SID803A ECU, please double check before bringing the car in to us.

Contact HDI Tuning

Thank you
Error occurred while sending email. Please try again later.